2013Cisco路由技术辅导:Cisco统一CME系统级功能的配置(10)
时间:2013-10-12
来源:思科认证(CISCO)考试网 浏览次数:201
【华夏培训网:中国教育培训第一门户】
配置数字语音端口:CISCO以语音和WAN接口卡VWIC(voice and wan interface cards)为路由提供E1端口,配置VWIC时:ds0-group用
配置数字语音端口:CISCO以语音和WAN接口卡VWIC(voice and wan interface cards)为路由提供E1端口,配置VWIC时:ds0-group用于E1的CAS连接;
配置CAS的PSTN端口
# show controllers e1 查看E1接口
(config)# controller e1 1/0
(config-controller)# framing esf
(config-controller)# linecode b8zs
(config-controller)# clock source line 向服务提供商接收接口时钟,连接PSTN时
(config-controller)# clock source internal 向PBX系统提供时钟信息,连接PBX时
(config-controller)# ds0-group 1 timeslots 1-30 type fxo-loop-start
注:可以将一E1接口分到多个ds0-group,用于连接多个接口
配置CCS的PSTN端口
(config)# isdn switch-type [交换机型号] 和服务提供商使用类型匹配
(config)# controller e1 1/0
(config-controller)# pri-group timeslots 1-30 注:信道16(17时隙)总是信令信道
配置拨号对等体
POTS拨号对等体:用于对传统语音连接定义语音可达信息
VoIP拨号对等体:用于为任意VoIP连接定义语音可达信息
配置路由器上FXS的POTS拨号对等体:
# show dial-peer voice summary 查看所有拨号对等体
(config)# dial-peer voice [tag] pots
(config-dial-peer)# destination-pattern [分机号码]
(config-dial-peer)# port 0/0/0
配置路由器与PBX或服务供应商的FXO的POTS拨号对等体:
(config)# dial-peer voice [tag] pots
(confgi-dial-peer)# destination-pattern 9T
(config-dial-peer)# no digit-strip 禁止自动号码移除
(config-dial-peer)# port 1/0:30
将所有拨打2xxx分机的呼叫都送至E1 1/0接口
配置VoIP拨号对等体:
(config)# dial-peer voice [tag] voip
(config-dial-peer)# destination-pattern 2…
(config-dial-peer)# session target ipv4:[ip_address]
(config-dial-peer)# codec g711alaw 若编码不匹配则不能接通
使用拨号对等体通配符
思科认证